Jeep Wrangler Door Removal: Step-by-Step Guide and Video Tutorial
The Wrangler is iconic, partially due to how customizable it is. One way you can customize your Wrangler is by removing the doors. Few things bring summer to mind like the sight of a Jeep with the top and doors off. While the process is pretty straightforward, it takes a bit of elbow grease. Let us show you the ropes.
Here’s are step-by-step instructions and a video tutorial on how to take the doors off of a Jeep Wrangler.
View Our New Wrangler Inventory
Wrangler Door Removal Step-by-Step Instructions
Ready to rock that summer look? You’ll need to grab the tool kit that came with your Jeep. By default, it’s stored in the center console of your Wrangler. Note that some of these steps may be slightly different on Wrangler models older than 2018.
- Roll down the windows to prevent damage during door removal and storage
- Remove the upper and lower exterior hinge pin screws with the T-50 Torx driver wrench
- Store the hinge pin screws in the bolt tray, located in the Wrangler door frame
- Remove plastic wiring access panel by sliding straight backwards toward rear of vehicle
- Push red locking tab on wiring harness upwards
- Push down on black security tab on the back of the wiring harness and lift up harness lever at the same time
- Pull wiring harness straight down towards floor to disconnect
- Store wiring harness in lower door basket
- Remove interior center check screw with T-50 Torx driver wrench
- Store check screw in bolt tray
- Open door and lift straight up, until hinge pins are clear of the vehicle
- Store doors in a cool, dry place
Not quite sure all these things are located? No sweat! Just check the official Jeep video tutorial below.
Wrangler Door Removal Video Guide
Want More Wrangler Info?
If you’d like to learn more about the Jeep Wranlger, give Juneks CDJR a call. We can walk you through things like top removal and other Wrangler care, as well as vehicle specs, features, and financing opportunities.
